Evaluation of the Parkson DynaSand filter for wastewater reclamation in California
Read Online

Evaluation of the Parkson DynaSand filter for wastewater reclamation in California by Bob Weinschrott

  • 399 Want to read
  • ·
  • 65 Currently reading

Published by Dept. of Civil Engineering, University of California in Davis, CA .
Written in English


  • Sewage -- Purification -- Filtration -- Testing.,
  • Water -- Purification -- Filtration -- Testing.,
  • Water reuse -- California.,
  • Effluent quality -- California.

Book details:

Edition Notes

Statementby Bob Weinschrott, George Tchobanoglous.
ContributionsTchobanoglous, George., University of California, Davis. Dept. of Civil Engineering.
LC ClassificationsTD429
The Physical Object
Paginationvi, 128 leaves :
Number of Pages128
ID Numbers
Open LibraryOL19439113M

Download Evaluation of the Parkson DynaSand filter for wastewater reclamation in California


Buy Evaluation of the Parkson Dynasand filter for wastewater reclamation in California by Weinschrott, Bob (ISBN:) from Amazon's Book Store. Everyday Author: Bob Weinschrott. STATE OF CALIFORNIA DEPARTMENT OF PUBLIC HEALTH DIVISION OF DRINKING WATER AND ENVIRONMENTAL MANAGEMENT TREATMENT TECHNOLOGY REPORT FOR RECYCLED WATER December TABLE OF CONTENTS 1. INTRODUCTION 2. GENERAL GUIDANCE 3. FILTRATION TECHNOLOGIES: Granular Media Type Filters DynaSand (Parkson Corp.) SuperSand (Waterlink . The DynaSand filter is a proven, reliable component with thousands of installations and over 30 years of operating history. Each DynaSand® filter is designed Why use the DynaSand D2® system to serve a different function within the process. The first stage filter uses larger sand grain size to give it more solids-handling capacity, and employs. State of California () Wastewater reclamation criteria. of the Parkson DynaSand. 2. detailed measures for a renovation were systemically discussed by technical and economic evaluation.

  University of California, Davis, CA Secondary and tertiary wastewater used for pilot plant testing at this site was obtained from an activated sludge process and a Parkson Dynasand continuous upflow filter, respectively [3]. Process flow used for pilot plant testing at this site was single - pass with 10% bleed for secondary and tertiary.   Evaluation of the Parkson DynaSand ™ Filter for Wastewater Reclamation in California, Department of Civil Engineering, University of California. -Conditions of acceptance include: 1) minimum bed depth of inches of sand with E.S. of 45 mm, 4) at least 6 minutes between pulses and no more than 25 pulses per filter run. -U.C. Davis Evaluation Report; "Evaluation of the PulsedBed Filter For Wastewater Reclamation in California", Sand filter systems pump well water into the top of a tank that is pressurized or gravity fed down through a porous (usually sand-rock) media. Periodically the filter media is backwashed to remove the entrained solids. Water filter backwash is conveyed to wastewater treatment facilities (WWTF) or is slurried to smaller settling tanks or ponds.

A 'read' is counted each time someone views a publication summary (such as the title, abstract, and list of authors), clicks on a figure, or views or downloads the full-text. on the filter surface. DynaSand filter. The DynaSand filter (Parkson Corporation, Fort Lauderdale, FL) is a continuous-backwash, deep-bed, up flow sand filter. The influent wastewater passes upwards through the downward-moving sand bed. The filtrate exits the filter from an effluent weir at top. While the filtrate exits from the top, the.   March Final 3/19/ PM. Page 4. Contents ISSNX March Vol. 21 No. 1 Issued March Page Page .   Municipal Wastewater Denitrification Evaluation Prepared by Bolton & Menk, Inc. SECTION 1 INTRODUCTION A. PROJECT BACKGROUND In , the Minnesota Pollution Control Agency (MPCA) announced an Emerging Contaminants Wastewater Initiative with a Request for Proposals for Wastewater Treatment Plant (WWTP) Pilot Projects.